With a container the size of the one in the picture, it is needed to minimize the amount coming out at the same time to prevent this method from failing. If you did this correctly the lava should endlessly fall without the container actually losing any liquid.
TERRARIA 1.1 FOR 1.3 FULL
At this point you can either empty the full Bucket elsewhere and collect the duplicated liquid in the shallow hole, or use another empty bucket to pick up the duplicated liquid.You should have a full bucket as well as some liquid covering 2 blocks of the hole, enough for another bucket of liquid. Aim your full Bucket at either the left or right side of inside the hole and click a total of 4 times to pour twice and withdraw twice.Make (or dig) a shallow hole 3 blocks wide and 1 block deep.Right: Where you should aim your bucket on either side.Ī different (and perhaps simpler when mastered) method to duplicate liquids is to: Two ways to make shallow holes in the ground. This method works flawlessly for both Lava and Water. Repeat as needed, of course this does not have to be a small W shape, there just needs to be one block separating the contents of your Bucket so that there is exactly half a bucket on the right side. With water you can also just spamclick the top of the w shape.Take half a Bucket of liquid from the right hole, which still fills your bucket completely.Empty your Bucket on top of the middle block.Watch the video above to see how the Liquid Duping is working in this model. blocks wide and 1 block deep, then put a block in the middle to make a W shape.
TERRARIA 1.1 FOR 1.3 GENERATOR
Terraria - Large Generator and Multiplier The most foolproof way to duplicate liquids is to: The type of timer used determines the speed at which the liquid will be produced. Take care not to leave it on too much, or you'll risk spilling liquids (especially lava) you can box the generator in to avoid such an occurrence. Link the pumps to a timer and activate it, and the liquid will eventually fill it up. Then, set up an Outlet pump so that the outgoing liquid falls into the container. Create a container, place the Inlet pump in it and fill it up with the desired liquid until the pump is fully submerged.